Bezel clips
Figure 91. Lower bezel removal for 5U server model with hot-swap power supplies
6. If you are instructed to return the upper bezel, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Replacing the upper bezel
This procedure applies only to the 5U server model with hot-swap power supplies.
To install the upper bezel on the 5U server model with hot-swap power supplies, complete the following
steps.
1. Read the safety information in
2. Insert the two tabs on the right-side of the upper bezel into the corresponding holes on the right side of
the chassis.
"Safety" on page v
and
"Installation guidelines" on page
.
Chapter 6
Removing and replacing components
31.
185