Table of Contents
Advertisement
Replacing the bezel
This procedure applies only to 4U server models with non-hot-swap power supplies.
To install the bezel on 4U server models with non-hot-swap power supplies, complete the following steps.
1. Read the safety information in
2. Insert the three tabs on the bezel into the corresponding holes in the front of the server.
3. Rotate the bezel to the server until it locks securely into place.
Figure 88. Bezel installation for 4U server model with non-hot-swap power supplies
4. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Removing the lower bezel
This procedure applies only to the 5U server model with hot-swap power supplies.
To access the hard disk drives on the 5U server model with hot-swap power supplies, you must first remove
the lower bezel.
1. Read the safety information in
2. If you are replacing a non-hot-swap component, turn off the server and all attached devices; then,
disconnect all power cords and external cables.
3. Press the blue-colored release button on the right side of the lower bezel and rotate the lower bezel
downward to disengage from the chassis.
Lenovo System x3100 M5 Installation and Service Guide
182
"Safety" on page v
and
"Safety" on page v
and
"Installation guidelines" on page
"Installation guidelines" on page
31.
31.
Advertisement
Table of Contents
Troubleshooting
