Lenovo 5457 Installation And Service Manual page 61

7. Touch the static-protective package that contains the new DVD drive to any unpainted metal surface on
the server; then, remove the DVD drive from the package and place it on a static-protective surface.
8. Stand the server back up in its vertical position.
9. Remove the drive retainer clip from the side of the drive cage of bay 1 or bay 2. Slide the drive retainer
clip to the front to remove it from the drive cage; then, snap the drive retainer clip into the screw holes on
the side of the drive.
10. Push the drive into the bay.
Figure 31. DVD drive installation for 4U server models with non-hot-swap power supplies
11. Carefully turn the server on its side so that it is lying flat.
Attention: Do not allow the server to fall over.
12. Connect the power (power connector P9) and signal cables to the drive.
Note: Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
If you have other devices to install, do so now. Otherwise, go to
To install a DVD drive on the 5U server model with hot-swap power supplies, complete the following steps.
For 4U server models with non-hot-swap power supplies, please see the above sub-section.
1. Read the safety information in
2. Follow the instructions that come with the drive to set jumpers or switches, if there are any.
Note: You might find it easier to install the new drive from the front and then attach the cables.
3. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
4. Unlock and remove the side cover (see
5. Remove the lower bezel (see
6. Remove the upper bezel (see
Drive retainer
clip
"Safety" on page v and
"Removing the side cover" on page
"Removing the lower bezel" on page
"Removing the upper bezel" on page
"Completing the installation" on page
"Installation guidelines" on page
34).
39).
39).
.
Chapter 2
75.
31.
Installing optional devices
49