Note: In the LSI RAID utility, SATA 1 represents hard disk drive in drive bay two and SATA 2 represents
hard disk drive in drive bay one (see
"Replacing a simple-swap hard disk drive" on page
209).
The following illustration shows the SATA connectors on the system board:
SATA 3
SATA 2
SATA 4
SATA 5
SATA 1
SATA 0
Figure 144. SATA connector location on system board for 4U server model with non-hot-swap power supplies
7. Push hard disk drive cage in until the release latches click into place.
Figure 145. Pushing hard disk drive cage into chassis for 4U server model with non-hot-swap power supplies
.
Chapter 6
Removing and replacing components
227