Lenovo 5457 Installation And Service Manual page 219

Figure 116. Tape drive installation for 4U server model with non-hot-swap power supplies
8. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
9. Connect one end of the applicable signal cable into the rear of the drive and make sure that the other
end of this cable is connected into the applicable connector on the system board.
10. Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
11. If you have another drive to install or remove, do so now.
12. Install the air baffle (see
13. Install the side cover (see
14. Stand the server back up in its vertical position.
15. Install the bezel (see
16. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Attention: If no tape drive is installed, it is important to reinstall the filler back to the bay.
To install a tape drive on the 5U server model with hot-swap power supplies, complete the following steps.
For 4U server models with non-hot-swap power supplies, please see the above sub-section.
1. Read the safety information in
2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
3. Set any jumpers or switches on the drive according to the documentation that comes with the drive.
4. Remove the filler from the drive cage, if any is present.
Drive retainer clip
"Replacing the air baffle" on page
"Replacing the side cover" on page
"Replacing the bezel" on page
"Safety" on page v
EMC filler
Tape drive
178).
175).
182).
and "Installation guidelines" on page
.
Chapter 6 Removing and replacing components
31.
207