Lenovo 5457 Installation And Service Manual page 550

Table of Contents

Advertisement

3. Undo recent system changes (settings or devices added). If not recent system changes, remove all
options then remove CMOS battery for 30 seconds to clear CMOS contents. Verify that the system
boots. Then, re-install options one at a time to locate the problem.
4. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
5. Reflash UEFI firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents
7. (Trained service technician only) Replace the system board.
• S.3060007: [S.3060007] A firmware fault has been detected in the UEFI image.
[S.3060007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. (Trained service technician only) Replace the system board.
• S.3070007: [S.3070007] A firmware fault has been detected in the UEFI image.
[S.3070007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. (Trained service technician only) Replace the system board.
• S.3108007: [S.3108007 ] The default system settings have been restored.
[S.3108007 ] The default system settings have been restored.
Severity: Error
User Response:
Complete the following steps:
1. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
• S.3818004: [S.3818004] The CRTM flash driver could not successfully flash the staging area. A
failure occurred.
[S.3818004] The CRTM flash driver could not successfully flash the staging area. A failure occurred.
Severity: Error
User Response:
Complete the following steps:
1. Continue booting sytem. If system does not reset, manually reset the system.
2. If the error is not reported on the subsequent boot, no additional recovery action is required.
Lenovo System x3100 M5 Installation and Service Guide
538

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3100 m5

Table of Contents