Connecting The Computers - G&D DP1.4-MUX2-NT Manual

Installation

Connecting the computers

NOTE:
To connect the (up to two) computers to the KVM switch, the interfaces
listed below are available for each computer.
The DisplayPort interfaces are placed at the top. The other interfaces are arranged
in blocks at the bottom edge.
Network B RS232
Network A PS/2 K/M USB K/M
Figure 3: Interfaces for connecting the computers
NOTE: The device variants DP1.4-MUX2-NT-R and DP1.4-MUX2-NT-MC2-R are
additionally equipped with two
signals can be switched as well.
Use the RS232-M/F-2 cable (available as an accessory) to connect the computer's
9-pin serial interfaces to this interface.
If you want to output the computer's audio signals via the speakers con-
Line In:
nected to the KVM switch, use one of the audio cables to connect the computer's
Line Out interface to this interface.
NOTE: Transmit the computer's mouse and keyboard data either via the PS/2 inter-
face PS/2 K/M or via the USB interface USB K/M.
Connect the computer's purple PS/2
PS/2 K/M:
socket (keyboard) to this interface.
If required, use the optional adapter MD6M-2xMD6F
(see figure on the right) to also connect the com-
puter's PS/2 mouse socket (green) to the KVM
switch.
USB K/M: For the transmission of mouse and key-
board data use one of the USB connection cables to connect one of the computer's
USB interfaces to this interface.
USB 3.0 CPU: Use one of the USB 3.0 connection cables to connect one of the com-
puter's USB 3.0 interfaces to this interface.
7 · G&D DP1.4-MUX2-NT
CPU In 1
Line In PS/2 K/M USB K/M
Speaker
RS232 CPU
DP Monitor DP CPU 1
CPU In 2
Line In PS/2 K/M USB K/M
USB 3.0
interfaces. With this variants
Mouse cable
DP CPU 2
USB 3.0
PS/2 (switch)
Keyboard cable
RS232