Connecting The Workstation Devices - G&D DP1.4-MUX2-NT Manual

Connecting the workstation devices

Network B RS232
Network A PS/2 K/M USB K/M
Speaker
Figure 2: Interfaces for connecting the workstation devices
NOTE:
The device variants DP1.4-MUX2-NT-R and DP1.4-MUX2-NT-MC2-R are
additionally equipped with a
can be switched as well.
signals
Connect the serial terminal device of the console to this interface.
NOTE:
If mouse and keyboard of the workstation are PS/2 devices, connect them to
the PS/2 K/M interface. If they are USB devices, connect them to the USB K/M
interfaces.
PS/2 Keyb.: Connect the connection cable of the
PS/2 keyboard.
If required, use the optional adapter MD6M-
2xMD6F(see figure on the right) to also connect the
mouse connection cable to the KVM switch.
USB K/M: Connect the connection cable of the USB
keyboard and/or USB mouse.
Connect the speakers to this interface to output the audio signals from the
Speaker:
active computer.
Connect the DisplayPort cable of the monitor to this interface.
DP Monitor:
NOTE:
For multichannel devices, the interfaces
interface.
Connect the DisplayPort cables of the other monitors to these interfaces.
USB 3.0: If you want to make USB devices available to the connected computers,
connect these devices to these interfaces on the front panel.
DP Monitor
CPU In 1
Line In PS/2 K/M USB K/M USB 3.0 Line In PS/2 K/M USB K/M
interface. With this variants
RS232 Device
DP CPU 1 DP CPU 2
CPU In 2
USB 3.0
PS/2 (switch)
Mouse cable
Keyboard cable
DP Monitor x are placed above this
G&D DP1.4-MUX2-NT · 6
Installation
RS232