Connection To Up To Two Networks; Connecting The Power Supply - G&D DP1.4-MUX2-NT Manual

Installation

Connection to up to two networks

If desired, connect the network interfaces with up to two local networks to access
the web application Config Panel from the networks and to send SNMP traps or sys-
log messages to these networks.
Network B RS232
Network A PS/2 K/M USB K/M
Figure 4: Interface for connecting the power supply
Plug in the category 5e (or higher) twisted-pair cable, which is available as
Network A:
an accessory. Connect the other end of the cable to a local network.
Network B: Plug in the category 5e (or higher) twisted-pair cable, which is available as
an accessory. Connect the other end of the cable to a local network.

Connecting the power supply

DP CPU 1 DP CPU 2
USB K/M USB 3.0
Figure 5: Interface for connecting the power supply
Connect a power cable to a mains socket and this socket.
Main Power:
Red. power: If desired, connect another power cable to a mains socket and this
socket. This provides the device with a second, redundant power supply.
9 · G&D DP1.4-MUX2-NT
CPU In 1
Speaker Line In PS/2 K/M USB K/M
DP Monitor
DP CPU 1
CPU In 2
USB 3.0 Line In PS/2 K/M USB K/M
Status Power
Red.
Main
Ready Ident.
Fail
System
DP CPU 2
USB 3.0
Main Power Red. Power