Connecting The Computers; Connecting The Tradeswitch Leds - G&D TradeSwitch2-USB Assembly, Installation And Operation Manual

Connecting the computers

NOTE: To connect the (maximum two) computers to the KVM switch, the inter-
faces as shown below are available for each computer.
The label (e.g.
CPU 1
spondent button on the front panel.
Console
Keyb./Mouse Line In Speaker Line In Line Out
Figure 3: Interfaces to connect the computers
Line In: I f the audio signals of the computers are to be output over the speakers which are
connected to the KVM switch, use one of the audio connection cables (Audio-M/M) to
connect the computer's Line Out interface to this interface.
Line Out: If you want to use a microphone or a headset at the console, use one of the
audio connection cables (Audio-M/M) to connect this interface to the computer's
microphone input.
USB 2.0: Use one of the USB connection cables (USB-AM/BM) to connect one of the
computer's USB interfaces to this interface.

Connecting the TradeSwitch LEDs

Console
Keyb./Mouse Line In Speaker Line In Line Out
Figure 4: Interfaces to connect the TradeSwitch LEDs
LED Out: Connect a TradeSwitch LED (TS-LED-2) to this interface and place the
TradeSwitch LED set on e.g. the monitor.
) assigns the interface to a specific computer and to the corre-
LED Out 1 LED Out 2
CPU 1 CPU 2
USB 2.0 Line In Line Out USB 2.0
LED Out 1 LED Out 2
CPU 1 CPU 2
USB 2.0 Line In Line Out USB 2.0
Installation
G&D TradeSwitch2-USB · 6