Temporarily Disabling The Network Filter Rules - G&D DP1.4-MUX2-NT Manual

Use of the Reset button

Temporarily disabling the network filter rules

By default, all network computers have access to the IP address of the system (open
system access).
You can use the web application to create network filter rules to control access to
the device. Once a network filter rule is created, open system access is disabled and
all incoming data packets are compared with the network filter rules.
If the currently defined network filter rules prevent access to the web application,
you can temporarily disable the network filter rules and then edit them.
How to temporarily disable network filter rules:
1. Press and hold the Reset button on the front panel of the device for five seconds.
IMPORTANT: Open system access is now active.
2. Use the web application Config Panel to edit the network filter rules stored in the
device and save the rules.
IMPORTANT: If you do not configure new network filters within 15 minutes,
the original settings are reactivated.
17 · G&D DP1.4-MUX2-NT