Command Safety System - Norton Clipper CB 311 Operating Instructions Manual

VERS.2017.11.22 CB311_MAN_EN

3.5 Command Safety system

1
Fig.4
2
The start and stop of the blade movement are controlled by the command handles (see figure
above). When the user has both hands on the handles, the blade can advance safely.
The same handles are used for pushing the sliding bench by hand to cut and to return the bench to
the initial position.
After positioning the block to be cut on the bench, grasp the ON-OFF buttons, 1 and 2 above, and
turn both of them to the ON position to turn on the blade.
During the cutting phase the handles must be maintained in the ON position during the cutting
operation.
When one or both handles are released in the OFF position, the blade movement stops.
Caution: Do not use your hands to clean the work platform during work. Use a brush with a
handle or a cut of wood.
Caution: Use sturdy gloves to handle the blade during maintenance.
Caution: If the machine is out of order due to fault or maintenance, always mark it with a
signboard.
17