VERS.2017.11.22
3.2
Tool assembly
The machine is sold ready to use with a blade already set and adapted to the machine.
For any intervention, follow the instructions given in the part "MAINTENANCE".
3.3
Electrical connections
Check that:
The voltage/phase supply corresponds to the information indicated on the motor plate.
Available power supply must have ground connection in conformity with safety regulations.
The connecting cables should have at least a 4 mm
3.4 Start-up and stoppage
Press the green push button to turn the blade on
After each cut, press the green push button again.
To stop the machine directly, press the red button or the emergency stop button
if a problem occurs.
The machine is equipped with a safety switch under the flywheel housing.
It is also equipped with an ON-OFF control system for the movement of the blade: "Safety control
system". The blade moves only if the operation buttons are in ON mode.
2
- section per phase.
Fig.3
CB311_MAN_EN
16