Charging The Battery; Water Cooling System - Norton clipper CS 352 B Operating Instructions Manual

VERS.2023.03.15 CS 352 B_MAN_EN

3.5 Charging the battery

This machine works with a battery, so you have to think about
charging it. A fast charger is available for this. It will take
between 1h and 1h30 to recharge a full battery charge. When
charging the battery, the charger fan turns on to prevent the
battery from heating up. The charger will stop automatically
once the battery is fully charged, but the fan will remain on for
a while to keep the battery cool.
NOTE: The battery must not be charged at a temperature equal to or lower than 5°C.

3.6 Water cooling system

Fill the water tank with clean water.
Open water-tap at blade guard (note that handle on water-tap should be in line with water-flow).
Ensure that water is flowing freely in the circuit and delivered adequately to both sides of the
blade, as insufficient water supply may result in premature failure of the diamond blade.
In case of frost, empty the water cooling system.
18