Square For Angle Cuts (Fig.24) - Norton Clipper CB 311 Operating Instructions Manual

VERS.2017.11.22 CB311_MAN_EN

5.7 Square for angle cuts (Fig.24)

This square can be placed either to the right or to the left of the blade with a simple procedure. Just
loosen knob (p), pull out aluminum support (o) and thread it onto the cross guide tube (u) to the right
of the blade. Then clamp aluminum support (o) in the desired position using knob (p). To angle the
square (s) use knob (r).
Fig 24
28