Cleaning And Lubrication; Checking Safety Devices - Norton Clipper CB 311 Operating Instructions Manual

VERS.2017.11.22
When the bearing on the back of the blade has a very deep furrow it must be replaced:
Bearing for upper blade guide: cod.62200.2rs = D30-D10-14
Bearing for lower blade guide: cod.6200.2rs = D30-D10-9
Example:
bearing to replace

6.4 Cleaning and lubrication

Caution ! All adjustment and maintenance procedures must be performed with the
machine off and power disconnected! It is prohibited to remove or tamper with the
guards. It is prohibited to clean the blade while it is moving.
Periodically clean the machine and remove deposits from the work table, lubricate the upper
flywheel stretching guide, lubricate the blade-guide rod and all joints to prevent rust from forming.
Remove any deposits on the flywheels to prevent vibrations and blade breakage. Always blow out
the blade guides.

6.5 Checking safety devices

Periodic check :
To check that safety devices operate properly keep to the following instructions:
CHECKING ELECTRICAL COMPONENTS (switch)
1) start up the machine;
2) press the switch's stop push-button (the machine should stop);
3) start up the machine again and press the emergency stop push-button (the machine should stop).
CHECKING ELECTRICAL COMPONENTS (limit switches):
1) start up the machine;
2) open the flywheel guards (the machine should stop);
3) start up the machine again and push the table to its travel limit towards the blade (the machine
should stop);
4) the machine has a safety limit switch that prevents it from being started up if the table is inclined
in its transportation position.
CAUTION: Periodically clean the limit switches to prevent formation of deposits that
prevent them from operating. Make sure that the piston goes CLICK ! (the machine
will not operate if the limit switch piston remains in)
CB311_MAN_EN
31