Norton Clipper CB 311 Operating Instructions Manual page 26

VERS.2017.11.22
WARNINGS
Absolutely avoid putting your hands in the cutting area when the blade is moving!
Do not operate the machine when breakdowns or defects occur: wait until they
have been removed.
When cutting use low thrust pressures and "slow" even forward feed speeds make sure the blade is
stopped when handling the block before and after the cutting phase.
Absolutely do not put your hands in the cutting area when the blade is moving.
IT IS FORBIDDEN TO CUT:
Stone, rocks, marble, granite, ceramics, concrete blocks, iron, etc.
IMPORTANT
For maximum machine durability and cutting precision always make the first cuts with
very low pressure levels, increasing pressure slowly until you reach the optimum
level based on the type of material to be cut.
CB311_MAN_EN
26