Water Cooling System; Starting The Machine - Norton clipper CM 352 Operating Instructions Manual

VERS. 04.04.2019

3.4 Water cooling system


Fill the water tray with clean water (to approximately 3cm from top) to ensure that bottom of the pump
is fully immersed in its decanting basket).

The blade must be well cooled on both sides. You can adjust the water flow by the means of the water
tap. Insufficient water supply may result in premature failure of the diamond blade. Make sure the water
hose and nozzles are not clogged.

The water pump must never run without water. Always make sure that there is enough water in the
water tray above the aspiration of the water pump.

In case of frost, empty the water cooling system from its water.

3.5 Starting the machine

To start the machine:

Open the cover on the front side of the switch and press the green button.
To stop the machine:

Press the red button or directly the emergency stop on the cover of the switch.
The switch activates or deactivates both motor and water pump.
14
MAN CM 352 EN