Table of Contents
Advertisement
VERS.2017.11.22
8 – FAULTS : CAUSES AND CURES
8.1 Fault-finding procedures
Should any fault occur during the use of the machine, turn it off, and isolate it from the electrical
supply. Any works dealing with the electrical system or supply of the machine can only be carried
out by a qualified electrician.
8.2
Trouble-shooting guide
Panne
Motor is not running
Motor stops during the cutting, but can
be restarted after a short period
8.3 Warranty
Warranty coverage is excluded on parts which are due to natural wear, thermal stresses, weather or
breakdowns caused by incorrect connections, installation, operation or lubrication or caused by
forceful interventions. Warranty coverage is excluded on electrical and electronic apparatus in case
of damages caused by inappropriate voltage (insufficient or excess voltages).
In addition no warranty coverage shall be recognized for damages caused by improper use or
misuse of the machine such as unsuitable modifications or repairs made by the owner or by third
parties under their own responsibility and also in case of intentional overloads of the machine.
Parts subject to wear (for example cutting blades, drive belts or drive chains, blade guides,
bearings, thrust bearings, condenser) as well as performance of all adjustment and calibration
works are totally excluded from the warranty.
Source possible
No electricity
Connection cable section
too small
Defective connection
cable
Defective switch
Defective motor
Cutting advance too quick
Defective blade
CB311_MAN_EN
Résolution
Check the electrical supply
(fuse for example)
Change connection cable
Change connection cable
CAUTION : can only be
solved by a qualified
electrician
Change motor or contact
motor manufacturer
Cut slowly
Change blade
33
Advertisement
Table of Contents
