Heartland VALUE Series Assembly Manual page 58

PARTS REQUIRED:
x2
7/16 x 47-7/8 x 48"
(1,1 x 122 x 122 cm)
Keep spacing between the center of the rafters
4
at the lower edge of the panel and secure with
(1) 2" nail into each rafter (Fig. E).
Move to the top of the panel and keep spacing
between the center of the rafters. Secure with
(1) 2" nail into each rafter (Fig. E).
Nail the roof panel using 2" nails 6" spaced
apart on edges and 12" apart inside panel.
Attach 47-7/8 x 48" roof panel flush to
first panel, flush at peak and with the 3/8"
measurement on trim (Fig. F, G).
Gable
Trim
Move to the opposite side of the roof and
5
repeat this process installing a 48 x 96"
and 47-7/8 x 48" panel.
Note the panels edges are offset from the
first panels installed.
Make sure panels are flush at the peak
(Fig H) and there is a 3/8" measurement
at the gable trims (Fig. J).
Nail the roof panel using 2" nails 6" spaced
apart
on edges and 12" apart inside panel.
ROOF PANELS
x1
7/16 x 48 x 96"
(1,1 x 122 x 244 cm)
3/8"
(9,5 mm)
Fig. G
3/4" GAUGE
BLOCK
Fig. E
NOTE: Measurements from inside of panels
22-1/2" 24"
(57 cm) (61 cm)
12"
(30,5 cm)
Flush
Flush
at peak
Fig. H
56
x108
2" (5 cm)
24" 24" 24"
(61 cm) (61 cm) (61 cm)
2" Nails
Flush
at peak
Fig. F
6"
(15 cm)
3/8"
(9,5 mm)
22-1/2"
(57 cm)
Fig. J