Heartland VALUE Series Assembly Manual page 46

PARTS REQUIRED:
x15
x20
Mark top of wall frames to measurement shown.
Locate Rafter centered on marks.
Hold rafter end flush to back wall and overhang. Secure from under overhang
with (2) 2" screws. (Fig. A)
2
Secure opposite end through panel into rafter end using (1) 2" screw (Fig. B)
3
Secure rafters at each end with (2) 3" screws. (Fig. B, Fig. C)
Repeat steps to install (5) rafters.
FINISH
You have attached your rafters. Proceed to attaching your soffit trim.
22-1/2"
(57 cm)
(2) 2"
Fig. A
(5 cm)
Screws
DOOR
2" (5 cm)
Dimensions are from inside of panel
Dimensions are to center of rafters
24" 24"
(61 cm) (61 cm)
Fig. C
ROOF
3" (7,6 cm)
24"
(61 cm)
At each end
(2) 3" screws
angle into 2 x 3
Flush
44
24" 22-1/2"
(61 cm) (57 cm)
(5 cm) Screw
Fig. B
2"