Heartland VALUE Series Assembly Manual page 28

PARTS REQUIRED:
x1
x1
RK
2 x 3 x 13" (5 x 7,6 x 33 cm) as spacer
Ensure your wall frame is square by installing (1) panel and squaring frame.
3
Place the 48 x 72" panel onto wall frame with primed side up as shown.
Note the lip and square edges.
Use the gauge block to mark the 3/4" measurement on the wall stud.
Use RK as a 1-1/2" gauge block at top.
Secure panel with (2) 2" nails in the corners (Fig. A).
4
Move to the opposite end. Using the long edge of the panel as a lever move the panel side-to-side until you have
a 3/4" measurement on the wall stud. Secure corner with (2) 2" nails (Fig. B).
5
Secure the panel using 2" nails 6" spaced apart on edges and 12" apart inside panel.
BEGIN HERE
There will be an overhang
at top and bottom
HINT: Use RK
as 1-1/2" gauge
48"
(122 cm)
BACK WALL
3/8 x 48 x 72"
(1 x 122 x 183 cm)
For squareness, maintain 3/4" and
1-1/2" measurement along panel edges.
3/4"
(1,9 cm)
1-1/2"
(3,8 cm)
Primed side up
12"
(30) cm
6"
(15 cm)
3/4"
GAUGE
BLOCK
3/4"
(1,9 cm)
x34
3/4" GAUGE
BLOCK
26
2" (5 cm)
2 Nails
1-1/2"
(3,8 cm)
3/4"
(1,9 cm)
Fig. A
1-1/2"
(3,8 cm)
3/4"
(1,9 cm)
Fig. B
2 Nails