Heartland VALUE Series Assembly Manual page 14

PARTS REQUIRED:
5/8 x 45 x 96"
x1
(1,6 x 114 x 243,8 cm)
Ensure your foor frame is square by installing (1) panel
and squaring frame.
BEGIN
Attach the 5/8 x 45 x 96" panel with the rough side up (painted-grid lines side) with the 45"
1
edge and corner flush to the floor frame (Fig A).
Secure panel with (2) 2" nails in the corners.
Move to the opposite side. Using the long edge of the panel as a lever, move the
2
panel side-to-side until the top corner is flush to the floor frame (Fig. B).
Secure panel with (2) 2" nails in the corners.
Check the floor frame is square by measuring diagonally across the frame corners. If the measurements are the
3
same your floor frame is square. The measurement will be approximately 170-9/16" (433,3 cm) (Fig. C).
Continue securing the panel with 2" nails 6" spaced apart on edges and 12" apart inside panel.
4
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
45"
(114 cm)
96"
(243,8 cm)
12"
(30 cm)
6"
(15 cm)
Flush
FLOOR PANELS (NOT INCLUDED)
Floor panels not included. See
page 3 for panel sizes
and quantities.
141"
(358 cm)
Grid lines up
3/4"
(1,9 cm)
DOOR
12
x62
2" (5,1 cm)
3/4"
(1,9 cm)
Flush
(2) Nails
(2) Nails
Flush
170-9/16"
(433,3 cm)
170-9/16"
(433,3 cm)
Fig. C
Fig. A
Fig. B