Heartland VALUE Series Assembly Manual page 38

PARTS REQUIRED:
x8
x41
2" (5 cm) x26
BEGIN
Center front wall on floor side-to-side.
1
Check the 64" door opening is held
before nailing.
Nail the front wall flush to the floor using
2" nails 6" spaced apart. Angle nails to hit
floor frame (Fig. A).
Nail the lower side wall corner to the side
wall trim with (1) 2" nail (Fig. B).
Be sure the measurement between the
2
panel edge and the trim is the same
along the entire length.
Secure with (1) 2" nail in the upper
corner (Fig. C).
Nail along the panel edge into the trim
using 2" nails spaced 6" apart.
3
Nail down the bottom plate using (2) 3"
nails between the wall studs. (Fig. D).
Screw through the front wall trim into the
top and bottom plates using (1) 3" screw
(Fig. E, Fig. F).
Repeat process to secure the left side of
the front wall.
You have finished standing your front wall.
4
FRONT WALL INSTALLATION
3" (7,6 cm)
3" (7,6 cm)
Nails
x4
6"
(15 cm)
CENTER
Fig. D
36
3" (7,6 cm)
64"
(162,6 cm)
6"
(15 cm)
2"
(5 cm)
Nail
2" (5 cm)
Nail
6"
(15 cm)
Fig. E
2" (5 cm)
Nail
Fig. A
Trim
Fig. B
Fig. C
Trim
Same
Measurement
Panel
3" (7,6 cm)
Screw
3" (7,6 cm)
Screw
Fig. F