Heartland VALUE Series Assembly Manual page 41

PARTS REQUIRED:
RK
x2
2 x 3 x 13" (5 x 7,6 x 33 cm)
x1
3/8 x 5-3/8 x 5-1/2" (1 x 13,6 x 14 cm)
Make a rafter jig to make sure all rafters are assembled the same.
2
Measure from corner of backwall and RK (already installed) as shown.
Secure RK on the flat square to back wall at measurement with (2) 3" screws.
3
Attach a second RK on edge and 3/8" thick angle trim piece as shown (Fig. A).
FINISH
You have finished building your rafter jig.
3" (7,6 cm) screw
[Must drive in all the way.]
End Cap
3/8 x 5-3/8 x 5-1/2"
(1 x 13,6 x 14 cm)
RAFTER JIG
RK
RK
(257,5 cm)
x3
Required, because rafter
is uneven at bottom.
2-1/2"
(6,4 cm)
Fig. A
101-3/8"
Important
measurement
39
3" (7,6 cm)
RK