Heartland VALUE Series Assembly Manual page 33

PARTS REQUIRED:
x1
Ensure your wall frame is square by installing (1) panel and
squaring frame.
BEGIN
Place the panel onto wall frame flush under overhang with primed side
1
up as shown (Fig. A).
Use the gauge block to mark the 3/4" measurement on the wall stud.
Secure panel with (2) 2" nails in the corners (Fig. B).
2
Move to the opposite end. Using the long edge of the panel as a lever
move the panel side-to-side until you have a 3/4" measurement on the
wall stud (Fig. C). Secure corner with (2) 2" nails.
3 Nail the panel using 2" nails 6" spaced apart on edges and 12" apart inside panel.
Flush panel
under
overhang
There will be
an overhang
at top and
bottom.
Flush
48"
(122 cm)
Fig. A.
BEGIN HERE
For squareness, maintain 3/4"
measurement along panel edge.
3/4"
(1,9 cm)
3/4" GAUGE
BLOCK
6" (15 cm)
12"
(30 cm)
Primed
side up
3/4"
(1,9 cm)
FRONT WALL
3/4" GAUGE
BLOCK
31
x34
2" (5 cm)
2 Nails
Flush
Fig. B
Fig. C
2 Nails
3/4"
(1,9 cm)
3/4"
(1,9 cm)