Module - Toshiba B-EX Series Key Operation Specification

8.12.2 MODULE

The following information related to the module setting is displayed.
・ MODULE TYPE
・ COUNTRY
・ TAG
・ RF CHANNEL
8.12.2.1 MODULE TYPE
・ NONE No RFID module is installed.
・ H1 B-EX700-RFID-H1-QM-R
・ H2 B-EX700-RFID-H2-R
・ U2 B-EX700-RFID-U2-EU-R (Europe, India)
B-EX700-RFID-U2-US-R (North America, Australia, Taiwan, Korea)
B-EX700-RFID-U4-R (Japan)
B-EX700-RFID-U4-EU-R (Europe)
B-EX700-RFID-U4-US-R (Korea)
U4 module preinstall model (B-EX4T1/EX4T2-GS18/TS18-CN-R) (China)
Note: This setting will become effective after the printer power is turned off, and back to on.
8.12.2.2 COUNTRY
The country code of the currently installed module is displayed.
If the module type is set to other than "U2", "INVALID" is displayed.
It is possible to change the country setting when the module type is set to "U2" and the actually installed
module type is U2-US or U2-EU. However, this menu is password-protected because changing the
country setting causes the output frequency to change.
The following message is displayed depending on the module type setting, the mounted module type,
and the module mount condition.
Module Type
parameter
NONE No module installed
H1/H2 B-EX700-RFID-H1-QM-R
B-EX700-RFID-H2-R
U2 No module installed.
B-EX700-RFID-U2-EU-R
B-EX700-RFID-U2-US-R
B-EX700-RFID-U4-R
B-EX700-RFID-U4-EU-R
B-EX700-RFID-U4-US-R
U4 module preinstall model
*1: Selectable country codes differ depending on the RFID module type. Multiple country codes may be
displayed when setting a country code, but be sure to select the country where the RFID module is
used. Setting a different country code is prohibited. In the case B-EX700-RFID-U4-R is installed in
B-EX4T1-TS25-R, be sure to select JPN. (A blank line may be displayed, but ignore it.)
For the selectable country codes, refer to Section 8.3.2.1 Module version and LCD message.
Module type and status
Country setting
done. *1
No country
setting done
145
Message
NONE
INVALID
No RFID Module
[ENTER] for Setting
Need Setting for use
[ENTER] for Setting