Toshiba B-EX Series Key Operation Specification page 86

8.4.1.6 RBN SAVE
・ TAG (Note 2) Enabled (When the head lever is set to the TAG position)
・ LABEL Enabled (When the head lever is set to the Label position)
(Note 2)
・ OFF Disabled.
・ TAG2 Enabled (When the head lever is set to the TAG position)
(Note 3)
・ LABEL2 (Note 3) Enabled (When the head lever is set to the Label position)
Note:
1. If this parameter is set to "Enabled" with no ribbon saving module installed, the ribbon becomes slack
and a print failure occurs. Care must be taken when setting this parameter.
Also, the ribbon saving option shall be selected depending on the head lever position. An incorrect
setting may disable the proper ribbon saving function.
2. Even if "TAG" or LABEL" is selected for B-EX4T2-G/T/H, B-EX4D2-G or B-EX4T3-HS, the setting
and the printer behavior will automatically be changed to "OFF" because the head-up function is not
available for these models.
3. TAG2 and LABEL2 are supported only by B-EX4T1-TS25-R V2.0 or later. The difference between
"ON:TAG" and "ON:TAG2", and between "ON:LBL" and "ON:LBL2", respectively, is the distance of
the non-print area where ribbon saving is performed. (In the case of 8 ips or faster)
8.4.1.7 PRE PEEL OFF
・ OFF Disabled
・ ON Enabled
Note:
1. The pre-peel off operation is automatically enabled when the print speed is set to 10 ips or faster for
the strip issue. However, the print speed may be corrected depending on the EX I/O parameter
setting as follows.
▪ EXI/O: TYPE 1 (Standard)
203 dpi model: 10 ips
300 dpi/305 dpi model: 8 ips
▪ EX I/O: TYPE 2 (Inline)
Specified speed
Accordingly, when the print speed is set to less than 10 ips, the pre-peel off operation is enabled only
when this parameter is set to ON.
2. The pre-peel off speed is the minimum forward feed speed of each model.
Feed speed
3 ips
2 ips
8.4.1.8 BACK SPEED
・ STD 3 ips
・ LOW 2 ips
8.4.1.9 TYPE OF RIBBON
・ CSO Outside wound ribbon
・ CSI Inside wound ribbon
* Applicable model: B-EX4T2 and B-EX4D2
* This parameter is not used for B-EX4D2.
Model
B-EX4T1-G/T, B-EX4T2-G/T
B-EX4T2-H, B-EX4T3-H
81