Toshiba B-EX Series Key Operation Specification page 159

8.12.5.3 HEADUP ACTION
This function is used for setting the head-up action during backward feeding of an RFID tag.
・ MODE1 Whether the print head is raised or not is determined depending on the system mode
setting (RBN SAVE) or command (issue command, feed command, or reverse feed
command).
・ MODE2 When an RFID module is installed in the printer and a minimum of 3-mm backward feeding
is performed, the print head is raised regardless of the system mode setting or command
setting.
<Supplementary explanation>
(1) Applicable model: B-EX4T1-TS25-R V2.2 or later
(2) When MODE2 is selected, the printer behavior will be as follows:
Head-up → Backward feeding → Stop → Head-down
(3) When MODE2 is selected with no RFID module installed, the action of MODE1 will be performed.
(4) When MODE2 is selected, the print head is raised in the following cases. (The print head is not
raised with the MODE1 setting.)
• Backward feeding during an auto forward wait
• Backward feeding to the print start position after a cut operation
• Backward feeding after a VOID printing due to an on-the-fly RFID writing error
• Backward feeding to the print start position after a peel-off operation
• Backward feeding to the print start position during a pre-peel-off operation
• Pre-backward feeding
• Backward feeding while the ribbon saving function or head-up function is not enabled in an issue
command, feed command or reverse feed command.
• Backward feeding by the issue command or feed command when a combination of the print speed
and the non-print area does not enable the use of the ribbon saving function or head-up function
• Backward feeding by a U2 command on the condition that it does not enable a head-up function
(feed amount = 20 mm or less).
154