Auto Configuration Mode; Outline Of The Auto Configuration Mode; Preparation For Usb Memory - Toshiba B-EX Series Key Operation Specification

11 AUTO CONFIGURATION MODE

11.1 OUTLINE OF THE AUTO CONFIGURATION MODE

When turning on the printer while holding down the [CANCEL] key, the printer starts the auto configuration
mode.
The auto configuration mode allows for automatically downloading the master firmware and restarting the
printer.
Power OFF

11.2 PREPARATION FOR USB MEMORY

To execute the auto configuration mode, the firmware file (*.bin) should be downloaded and the dedicated
CFG file need to be created in the USB memory in advance. To enter the auto configuration mode, the
RTCUSB host, USB memory, correct CFG file need to be all prepared. Lack of any one of these disables
shifting to the auto configuration mode, but causes the printer to start in the online mode.
Each file is saved in the SYSTEM directory created in the root directory for the USB memory.
Example: When BOOT/MAIN/CG are downloaded:
/ATA0/SYSTEM/B-EX-BOOT-Vx.x-xx.bin
/ATA0/SYSTEM/B-EX-MAIN-Vx.x-xx.bin
/ATA0/SYSTEM/B-EX-CG-Vx.x-xx.bin
/ATA0/SYSTEM/AUTOCONFIG.CFG
[CANCEL]
[PAUSE]/[MODE]/
[CANCEL]/[ENTER]
[ENTER]
(1) Power off state
(2) Turn on the printer while holding down the [CANCEL]
key.
(3) Auto configuration mode display
(4) Press the [PAUSE], [MODE], [CANCEL] or [ENTER]
key to show the next screen.
(5) Confirmation display
(6) Select "OK" and press the [ENTER] key.
* When "CANCEL" is selected, the printer returns to the
online state without downloading the firmware.
(7) The firmware is being downloaded.
(8) After downloading is completed, the printer will be
placed in the online state
182