Other - Toshiba B-EX Series Key Operation Specification

8.12.4.9 ANTENNA POSITION
・ FRONT ... Reserved
・ CENTER ... Reserved
・ REAR
This parameter, used for an RFID calibration, is to select the combinational position of the RF antenna
and the wave director. A "usable" antenna position must be selected for this parameter. Otherwise, the
printer operation is not guaranteed. (Refer to Section 6.7.1 Outline of the RFID Calibration.)
Applicable model: B-EX4T1-G/T C1.4 or later
For details of the RFID calibration, refer to Section 6.7 RFID CALIBRATION.
Antenna position
FRONT
CENTER
REAR

8.12.5 OTHER

The following information related an RFID is displayed.
・ TAG CHECK
・ MULTI WRITE
・ HEADUP ACTION
・ CARRIER SENSE
*1. Applicable model : B-EX4T1-TS25-R V2.2 or later.
8.12.5.1 TAG CHECK
OFF
ON (ID)
ON (ACCESS PASSWORD)
Antenna rotation
0°
*1
Error tag detection is disabled.
Though a tag is read before writing data on it, data is always written on the
tag whatever data is set as the header data.
Error tag detection is enabled.
A tag (EPC area for GEN2 tags) is read before writing data on it and data
is written on the tag only when the header data is "A5A5".
Error tag detection is enabled only for GEN2 tags.
The access password area of a tag is read before writing data on it. Only
when the data read matches the access password setting data, the data is
written on the tag.
Wave director position
0 mm
152
Application
Usable
Unusable
Unusable