Toshiba B-EX Series Key Operation Specification page 107

[Procedure for label having less than the minimum label pitch for each issue speed when the rotary
cutter is used]
When the following conditions are all met, the cut operation for the last label to be cut is performed
as follows.
Forward feed to the cut position → Cut while feeding → Feed stops →
Head lifted → Backward feed to the home position → Head lowered
Conditions: Issue Command, Feed Command and Eject Command received
Label pitch: Less than the minimum label pitch for each issue speed, cut performed,
transmissive sensor designated, cut position fine adjustment of ±10.0 mm or less, and
issue mode "C"
* For the issue command, this procedure is effective only when the next issue
command is not received at the last label to be cut.
* The print head can be lifted/lowered only when the optional ribbon saving module
is installed and the ribbon saving function is set to ON with the parameter setting
menu. When the ribbon saving module is not installed, the print head is not lifted or
lowered.
Note: 1. If the bottom edge of the last label advances past the feed roller while
the print head is lifted during label feeding to cut, the sensor may not
be able to detect an error even if the label cannot be fed any more.
2. If the head-up solenoid temperature is high when a cut issue is about
to be performed with the head lifted, the head may not be lifted .
102