Toshiba B-EX Series Key Operation Specification page 105

Note:
[Method 2] Adjust the cut position fine adjustment value.
When this procedure is used, one or more printed labels are left between the head
and the cutter. Therefore, these labels need to be removed by issuing or feeding
them.
(a) Cut position fine adjustment value calculation
The cut position fine adjustment value can be calculated using the following
method. If a calculated value does not work to enable the feeding backward to
the proper home position, the cut position needs to be readjusted with another
value.
Cut position fine
adjustment value
Ex) Label pitch: 30.0 mm
Cut position fine
adjustment value
1. If the bottom edge of the last label advances past the feed roller while
the print head is lifted during label feeding to cut, the sensor may not be
able to detect an error even if the label cannot be fed any more.
2. If the head-up solenoid temperature is high when a cut issue is about to
be performed with the head lifted, the head may not be lifted.
(Number of labels left
=
between the head and cutter)
32.8 mm
=
Label pitch
=
= 1 × 30.0 mm
= +30.0 mm
100
×
(Label pitch)
× (Label pitch)
* Any decimal remainders are
rounded off.
32.8 mm
× (30.0 mm)
30.0 mm