Stop Input And Reset Input - IDEC SmartAXIS FT9Z-1A01 User Manual

5: S F
P ECI AL UN CTI ON S

Stop Input and Reset Input

As described on "Start/Stop Operation" on page 4-19, the SmartAXIS can be started and stopped using a stop input or reset input,
which can be designated from the Function Area Settings menu. When the designated stop or reset input is turned on, the
SmartAXIS stops operation. For the system statuses in the stop and reset modes, see "Start/Stop Operation Using the Power
Supply" on page 4-20.
Since these settings relate to the user program, the user program must be downloaded to the SmartAXIS after changing any of
these settings.
Programming WindLDR
From the WindLDR menu bar, select Configuration > Run/Stop Control.
1.
The Function Area Settings dialog box for Run/Stop Control appears.
Click the check box under the Stop and Reset Inputs.
2.
Stop Input: Click the check box on the left of Use Stop Input and type a desired input number available on the SmartAXIS in the Stop
Input field.
Reset Input:
Click the check box on the left of Use Reset Input and type a desired reset number available on the SmartAXIS in the
Reset Input field.
This example designates
input I0 as a stop input
and input I1 as a reset
input.
Default: No stop and reset inputs are designated.
Click the OK button.
3.
5-4
Resets all Function Area Settings
values to defaults.
S A XI S P / L U '
M AR T R O I TE SER S
M FT9Y-B 1378
ANUAL