Checking/Clearing Error Information - IDEC SmartAXIS FT9Z-1A01 User Manual

6: HM I F
UN CTI ON

Checking/Clearing Error Information

When an error occurs while the SmartAXIS is running, an error message is displayed on the LCD. This section describes the steps
for checking the details and clearing the error.
When an error occurs, the following message is displayed.
1.
When an error occurs while SmartAXIS
is running and the SmartAXIS stops
Error!
PLC is stopped.
Press OK button for
more details.
Press and hold the
2.
General Error
Execution Error 0
Clear Error
Error details can also be checked from Error Status on the system menu.
Select the error type with the
3.
Only errors that have occurred are displayed.
General Error
Power failure
Watchdog Timer
Press the (ESC) button.
4.
Select Clear Error with the
5.
General Error
Execution Error 0
Clear Error
Select Yes with the
6.
Do you want to
clear error code?
No
Yes
General errors and user program execution error are cleared.
Note: For details on error information, see "Troubleshooting" on page 14-1.
6-20
When an error occurs while SmartAXIS is
running and the SmartAXIS continues running
PLC is running.
Press OK button for
more details.
(OK) button. The error code is displayed.
3
(up) and (down) buttons and press the
3
(down) button and press the
3
(down) button and press the
S A XI S P
M AR T R O
Error!
(OK) button.
(OK) button.
/ L U ' M FT9Y-B 1378
I TE SER S ANUAL
(OK) button.