Advertisement
12. Attaches the wire saddle B and the wire
saddle C to right upper section of the
machine and then release two hooks of
the thir.
13. Attach the edging to the aperture part.
14. Pass the key counter electrical wires
through the wire saddle B and the wire
saddle C and then pull out from the
aperture part.
15. Pass the key counter wire through the
edging.
Service Manual
Wire saddle C
Wire saddle B
Wire saddle C
Key counter
electrical wires
Aperture
1-2-28
Edging
Figure 1-2-34
Wire saddle B
Binding band
Connector
Figure 1-2-35
2NP
Y116141-8
Advertisement
