Advertisement
22. Connect the key counter signal cable to
the key counter electrical wires.
23. Fit the key counter cover to the
machine using the M4 x 6 screw.
24. Fit the rear cover using eight screws.
25. Insert the key counter into the key
counter socket assembly.
26. Turn the main power switch on and
enter the maintenance mode.
27. Run maintenance item U204 and select
[Key-Counter] (see page P.1-3-93).
28. Exit the maintenance mode.
29. Check that the message requesting the
key counter to be inserted is displayed
on the touch panel when the key coun-
ter is pulled out.
30. Check that the counter counts up as
copies are made.
Y116141-8
Key counter electrical wires
Key counter
elecrtical wires
Key counter
signal cable
Figure 1-2-28
1-2-23
M4 x 6 screw
Key counter
cover
Figure 1-2-28
Service Manual
2NP
Advertisement
