Advertisement
Code
Contents
2310
Fuser motor startup error
Fuser motor is not stabilized
within 3 s since the motor is
activated.
2500
Conveying motor 2 steady-
state error
The rated speed signal
detected the stability OFF
continuously for 1 s after the
conveying motor 2 stabilizes.
2510
Conveying motor 2 startup
error
Conveying motor 2 is not sta-
bilized within 2 s since the
motor is activated.
Y116141-8
Causes
Defective connec-
Reinsert the connector. Also check for conti-
tor cable or poor
nuity within the connector cable. If none,
contact in the con-
replace the cable.
nector.
Fuser motor and engine PWB (YC17)
Defective drive
Check if the rollers and gears rotate
transmission sys-
smoothly. If not, grease the bushings and
tem.
gears. Check for broken gears and replace if
any.
Defective motor.
Replace the fuser motor.
Defective PWB.
Defective connec-
Reinsert the connector. Also check for conti-
tor cable or poor
nuity within the connector cable. If none,
contact in the con-
replace the cable.
nector.
Conveying motor 2 and video PWB (YC28)
Defective drive
Check if the rollers and gears rotate
transmission sys-
smoothly. If not, grease the bushings and
tem.
gears. Check for broken gears and replace if
any.
Defective motor.
Replace the Conveying motor 2.
Defective PWB.
Defective connec-
Reinsert the connector. Also check for conti-
tor cable or poor
nuity within the connector cable. If none,
contact in the con-
replace the cable.
nector.
Conveying motor 2 and engine PWB (YC28)
Defective drive
Check if the rollers and gears rotate
transmission sys-
smoothly. If not, grease the bushings and
tem.
gears. Check for broken gears and replace if
any.
Defective motor.
Replace the conveying motor 2.
Defective PWB.
1-4-27
Check procedures/
corrective measures
1. Check the engine software and upgrade
to the latest, if necessary.
2. Replace the engine PWB and check for
correct operation (see page 1-5-33).
1. Check the engine software and upgrade
to the latest, if necessary.
2. Replace the video PWB and check for
correct operation (see page 1-5-48).
1. Check the engine software and upgrade
to the latest, if necessary.
2. Replace the engine PWB and check for
correct operation (see page 1-5-33).
2NP
Service Manual
Advertisement
