Advertisement
(4) Detaching and refitting the power source PWB
Procedure
1. Remove the rear cover.
(See page 1-5-4)
2. Remove seven screws and then
remove the power source box cover.
3. Remove all connecters from the power
source PWB.
4. Remove eight screws and then remove
the power source PWB.
5. Check or replace the power source
PWB and refit all the removed parts.
Y116141-8
Screw
Screws
Screw
Screw
Screws
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Screw
1-5-47
Power source
box cover
Figure 1-5-86
PWB connector
Power source PWB
Figure 1-5-87
Service Manual
2NP
Advertisement
