Advertisement
Item No.
U411
* : If the target values are not obtainable automatically, manually enter the following target
values in the following manner and perform adjustment.
1. Enter the target values which are shown at the bottom of the specified original
(P/N: AVGR14938B) executing maintenance item U425.
2. Set a specified original on the DP face up.
3. Enter maintenance item U411.
4. Select [Target].
5. Select [U425] and press the start key.
6. Select [DP FaceUp (Chart1)].
7. Select [Input].
8. Press the start key. Auto adjustment starts.
Method: [DP FaceDown (Chart1)]
To automatically enter the target value
1. Set a specified original (P/N: AVGR14938B) on the DP face down.
2. Enter maintenance item U411.
3. Select [Target].
4. Select [Auto] and press the start key.
5. Select [DP FaceDown (Chart1)].
6. Select [All].
All
7. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
* : If the target values are not obtainable automatically, manually enter the following target
values in the following manner and perform adjustment.
1. Enter the target values which are shown at the bottom of the specified original
(P/N: AVGR14938B) executing maintenance item U425.
2. Set a specified original on the DP face down.
3. Enter maintenance item U411.
4. Select [Target].
5. Select [U425] and press the start key.
6. Select [DP FaceDown (Chart1)].
7. Select [All].
8. Press the start key. Auto adjustment starts.
Service Manual
Display
Executing the adjustment in the DP scanning section (second
side) for magnification, leading edge timing, center line, MTF
filter, input gamma and matrix
Description
Description
1-3-136
2NP-2
Y116141-8
Advertisement
