Advertisement
Item No.
U415
Adjusting the print position automatically
Description
Automatically adjusts timings at the print engine.
Adjustment for leading edge timing, center line and margin.
Purpose
Used to make respective auto adjustments for the print engine.
Method
1. Load A3/ledger paper.
2. Press the start key.
3. Select [Execute].
4. Press the start key. A test pattern is outputted
5. Set the output test pattern as the original.
6. Press the start key.
Automatically performs adjustment from the top to bottom cassettes.
7. When normally completed, [OK] is displayed.
If a problem occurs during auto adjustment, error code is displayed.
Error Codes
Codes
SFFF
CFFF
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Y116141-8
S001
Black band is not detected (main scanning direction far end)
S002
Black band is not detected (main scanning direction near end)
S003
Black band is not detected (auxiliary scanning direction leading edge)
S004
Black band is not detected (auxiliary scanning direction trailing edge)
S005
Auxiliary scanning direction skew error (1.5 mm or more)
S006
Main scanning direction skew error (1.5 mm or more)
S007
Original error (detection of reverse original paper)
S008
Original error (page mismatch)
Scanner other error
C101
Adjustment value error (main scanning direction magnification)
C102
Adjustment value error (auxiliary scanning direction magnification)
C103
Adjustment value error (leading edge timing)
C104
Adjustment value error (center line)
C105
Adjustment value error (B margin)
C106
Adjustment value error (A margin)
C107
Adjustment value error (C margin)
C108
Adjustment value error (D margin)
Controller other error
Description
Description
1-3-141
2NP
Service Manual
Advertisement
