Acquisitionmode; Acquisitionstart; Acquisitionstatus - Baumer CX Series Operating Manual

Baumer
11.1.5

AcquisitionMode

Sets the acquisition mode of the device. It defines mainly the number of frames to capture dur-
ing an acquisition and the way the acquisition stops.
INFO
The camera must be stopped before this feature can be edited.
Name
Category
Interface
Access
Unit
Values
11.1.6

AcquisitionStart

Once image acquisition has started, the camera processes the images in three steps:
1. Determining the current set of image parameters
2. Sensor exposure
3. Readout from the sensor
This process is then repeated until the camera is stopped.
Name
Category
Interface
Access
Unit
Values
11.1.7

AcquisitionStatus

Reads the state of the internal acquisition signal selected using AcquisitionStatusSelector.
Name
Category
Interface
Access
Unit
Values
V1.1 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2
AcquisitionMode
AcqusitionControl
IEnumeration
Read / Write
-
Continuous Without external events frames are continuously acquired until stop
by command AcquisitionStop.
MultiFrame In this mode a predefined number of frames will be captured after
AcquisitionStart. The AcquisitionFrameCount controls the number
of captured frames. Next acquisition stops automatically.
Single- In this mode the camera will acquire another image after Acquisi-
Frame tionStart. Next acquisition stops.
AcquisitionStart
AcqusitionControl
ICommand
Write only
-
-
AcquisitionStatus
AcqusitionControl
IBoolean
Read only
-
true = 1 (On)
false = 0 (Off)
GenICam Camera Features
Operating Manual
| 11
77