Table of Contents
Advertisement
Baumer
11.15
Category: SequencerControl
Category for the Sequencer Control functions.
The Sequencer enables acquisition of an image series with automated camera re-parameteriza-
tion based on events and signals. For doing so, the camera parameterization of each step is
stored in so called Sequencer Sets.
Stringing together a number of these Sequencer Sets results in a sequence. The connection of
sequences is done by using different paths. Alongside the camera functions the path related
functions are also part of a Sequencer Set.
Sequencer Sets
Sequencer Sets combine camera features – similar to User Set – and Sequencer (set and path)
related parameters.
Parameterization of several camera functions can be controlled via Sequencer and saved to Se-
quencer Set. Information for switching via different paths is also stored.
This camera functions can be:
ExposureTime
n
Gain
n
Region of Interest (OffsetX / OffsetY / Width / Height)
n
UserOutput
n
Counter
n
Sequencer controllable camera features
ExposureTime
Gain (All)
Region of Interest:
UserOutputValueAll
UserOutputValue
Sequencer set and path related features
Each path involves:
the destination for the set switch-over mapped in feature SequencerSetNext
n
the signal change of state acting as switchover trigger and mapped as SequencerTrigger-
n
Source
the change of state acting as switch-over trigger and mapped as SequencerTriggerActiva-
n
tion
Similar to User Sets the camera's current parameterization will be overwritten when loading Se-
quencer Set and activating Sequencer.
V1.1 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2
CounterEventSource
CounterEventActivation
CounterResetSource
OffsetX, OffsetY,
CounterResetActivation
Width, Height
CounterDuration
TriggerMode
Camera feature values
Set #
Path 0
Path 3
Path 1
Path 2
GenICam Camera Features
Operating Manual
|
11
181
Advertisement
Table of Contents
