Lens Mount; Filter Exchange - Baumer CX Series Operating Manual

5 | Installation
5.5

Lens mount

Avoid contamination of the sensor and the lens by dust and airborne particles when mounting
the lens to the device!
Therefore the following points are very important:
Install the camera in an environment that is as dust free as possible!
n
Keep the lens mount covered if no lens is attached
n
Hold the camera downwards with unprotected sensor.
n
Avoid contact with any optical surface of the camera!
n
5.6

Filter exchange

Color cameras integrate a filter. This filter may limit the sensor use in certain applications.
To replace the filter, proceed as follows.
NOTICE
Dust-contaminated optical surfaces
Prevent filter, sensor and lens from contamination by dust and suspended matter!
Any filter exchange only in a dust-free room and using clean tools!
1 Assembly tool
3 Filter
Instruction:
a) Place the mounting tool (1) into the sensor opening. Place both front pins into the holes pro-
vided at the filter support (2).
b) Turn filter support (2) until the lugs can be seen in the guide grooves (4).
c) Remove the filter support (2).
d) Carefully remove the filter (3). When doing so, do not touch the sensor!
e) Insert a new filter into the sensor opening.
f) Replace the filter support (2).
g) Turn the filter support (2) until the lugs are no longer visible in the guide grooves (4).
34
1 2 3
Operating Manual
4
2 Filter support
4 Guide grooves
VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 | V1.1
Baumer