Balancewhiteautostatus; Brightnessautonominalvalue; Brightnessautopriority - Baumer CX Series Operating Manual

11 | GenICam Camera Features
11.4.8

BalanceWhiteAutoStatus

Status of BalanceWhiteAuto.
Name
Category
Interface
Access
Unit
Values
11.4.9

BrightnessAutoNominalValue

Sets the nominal value for brightness in percent of full scale. It will be adjusted according to pa-
rameterization in BrightnessAutoPriority.
Name
Category
Interface
Access
Unit
Values
11.4.10

BrightnessAutoPriority

The function set the highest priority auto function to adjust the brightness.
INFO
Provided BrightnessAutoPriority is set to GainAuto, image brightness can be increased by a
higher value in Gain. Though this can cause image noise, but the Framerate will not be re-
duced.
100
BalanceWhiteAutoStatus
AutoFeatureControl
IEnumeration
Read only
-
ColorGainsTooHigh The BalanceWhiteAuto calculation failed since at least one
Initial
Start
Success
Underrun
BrightnessAutoNominalValue
AutoFeatureControl
IFloat
Read / Write
-
5 - 95 (Increment: 1)
Operating Manual
of the calculated color gains exceeds the maximum value.
BalanceWhiteAuto has never been started.
BalanceWhiteAuto is waiting for statistics data.
The last BalanceWhiteAuto calculation was successful.
The BalanceWhiteAuto calculation failed since at least one
color-channel shows invalid statistic data.
VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 | V1.1
Baumer