Baumer
11.7.4
CounterReset
Executes software reset and start of the selected Counter. Counter starts counting events im-
mediately after reset unless Counter Trigger trigger is active. CounterReset is to reset Counter
independently of CounterResetSource. To disable Counter temporarily, set Coun-
terEventSource = Off.
INFO
Note that the value of Counter at time of reset is automatically saved and reflects in CounterVal-
ueAtReset.
Name
Category
Interface
Access
Unit
Values
11.7.5
CounterResetActivation
Selects the activation mode of the CounterResetSource signal.
Name
Category
Interface
Access
Unit
Values
11.7.6
CounterResetSource
Selects the signals that will be the source to reset Counter.
Name
Category
Interface
Access
Unit
Values
V1.1 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2
CounterReset
CounterAndTimerControl
ICommand
Write only
-
-
CounterResetActivation
CounterAndTimerControl
IEnumeration
Read / Write
-
RisingEdge
Resets the counter on the rising edge of the signal.
FallingEdge
Resets the counter on the falling edge of the signal.
AnyEdge
Resets the counter on the falling or rising edge of the selected
signal.
CounterResetSource
CounterAndTimerControl
IEnumeration
Read / Write
-
see table(s) below
GenICam Camera Features
Operating Manual
|
11
111