10Sequencersetselector; 11Sequencersetstart; 12Sequencertriggeractivation - Baumer CX Series Operating Manual

Baumer
11.15.10 SequencerSetSelector
Selects Sequencer Set to which related function parameters will apply.
Name
Category
Interface
Access
Unit
Values
11.15.11 SequencerSetStart
Sets the start Sequencer Set, which is the first set used.
Name
Category
Interface
Access
Unit
Values
11.15.12 SequencerTriggerActivation
Defines the signals edge to trigger Sequencer.
Name
Category
Interface
Access
Unit
Values
V1.1 | VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2
SequencerSetSelector
SequencerControl
IInteger
Read / Write
-
0 ... 127 (Increment: 1)
SequencerSetStart
SequencerControl
IInteger
Read / Write
-
0 ... 127 (Increment: 1)
SequencerTriggerActivation
SequencerControl
IEnumeration
Read / Write
-
AnyEdge Specifies that the trigger is considered valid on the falling or
rising edge of the source signal.
FallingEdge Specifies that the trigger is considered valid on the falling edge
of the source signal.
LevelHigh Defines trigger applied as long as source signal is on high.
LevelLow Defines trigger applied as long as source signal is on low.
RisingEdge Specifies that the trigger is considered valid on the rising edge
of the source signal.
GenICam Camera Features
Operating Manual
| 11
185