18Sensorshuttermode - Baumer CX Series Operating Manual

11 | GenICam Camera Features
11.12.18 SensorShutterMode
Sets the sensor shutter mode of the camera. The sensor shutter mode depends on the Trigger-
Mode.
Name
Category
Interface
Access
Unit
Values
Global Reset - General Information
Cameras with Rolling-Shutter sensor and enabled shutter mode GlobalReset, start all frame
lines simultaneously at exposure, however the end of exposure is delayed by the offset in the
previously read line. The exposure time for each line gradually lengthens. Data readout for each
line begins immediately at line exposure. Readout time for each line is the same, but times of
beginning and ending are staggered.
This shutter mode provides the benefit of reduced image artifacts that are typical for Rolling
Shutter. However, since exposure covers the entire image, brightness may gradually increase
from image top to bottom.
Trigger
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
Line 7
Line n-3
Line n-2
Line n-1
Line n
168
SensorShutterMode
ImageFormatControl
IEnumeration
Read / Write
-
GlobalReset
Rolling
Global
t
TriggerDelay
Operating Manual
The shutter opens at the same time for all pixels but ends in a
sequential manner. The pixels are exposed for different
lengths of time.
The shutter opens and closes sequentially for groups (typically
lines) of pixels. All the pixels are exposed for the same length
of time but not at the same time.
The shutter opens and closes at the same time for all pixels.
All the pixels are exposed for the same length of time at the
same time.
...
VCXG.2 / VCXG.2.XC / VCXG.2.I / VCXU.2 | V1.1
Baumer
Time
Shutter
Exposure
Readout