Table of Contents
Advertisement
5.3. Requirements for Mounting
Danger to life due to fire or explosion
Despite careful construction, electrical devices can cause fires.
Do not mount the system in areas containing highly flammable materials or gases.
Do not mount the system in potentially explosive atmospheres.
5.3.1. Basic Requirements
The SMILE-G3 system is suitable for indoor and outdoor use.
Do not install the inverter in a place where a person can easily touch it; the
housing and heatsink are hot during operation.
Do not engage screws into tapped holes using a Hammer Driver, Impact Driver or
"Rattle gun". Do not damage screw or hole threads by tightening with too much
torque.
Do not mount the system in areas with flammable or explosive materials.
Do not mount the inverter at a place within children's reach.
Do not mount the system outdoors in areas of high salt mist likelihood where
corrosion may cause damage. Ana area of high slat-mist likelihood refers to
regions within 500m of the coast or other areas prone to sea breezes.
5.3.2. Mounting Environment Requirements
The system must be mounted in a well-ventilated environment to ensure
adequate heat dissipation.
Do not mount in a location that will be exposed to direct sunlight. When mounted
under direct sunlight, the power of the system may be derated due to additional
temperature rise and the longevity of the product will be reduced.
Mount the system in a sheltered place or mount an awning over the product.
The optimal temperature range for the battery pack to operate is from15 to 30℃.
Favour location inside, under cover, or generally protected from the elements and
from the more extreme temperatures (e.g. in a garage).
Do not place near water sources like downpipes or sprinklers.
If the battery pack is mounted in the garage, ensure the product is adequately
protected from potential mechanical impact (in compliance with AS3000).
31
Advertisement
Table of Contents
Troubleshooting
