Table of Contents
Advertisement
66
The safety standard must be set correctly
If you select a safety standard which is not valid for your country and purpose, it can
cause a disturbance in the energy storage system and lead to problems with the
Network Operator. When selecting the safety standard, you must always observe the
locally applicable standards and directives as well as the properties of the PV system
(e.g. PV system size, grid-connection point).
If you are not sure which safety standard is valid for your country, region or
purpose, contact your Network Operator for information on which safety
standard is to be used.
If there is a WiFi module, please choose "Including WiFi Module" as "Yes", the APP
will jump to the WiFi configuration page, and please refer to section 9.3.
A Note on setting Feed-In limits with multiple PV systems
If the Alpha is installed with DC-connected Solar Panels as well as with an existing,
ac-coupled PV system, Installers may need to set a Feed-In limit to comply with Local
Regulations.
The Feed-in limit should be set to the total Phase feed-in limit set by the network
operator (typically 5kW), regardless of the size of the existing ac-coupled PV system.
Only set the feed-in limit to zero if the Network operator has dictated zero feed-in
from the house.
7.2. Register on AlphaCoud
7.2.1. Register an Installer Account
If you do not already have an Installer account, you can create a new account on our
webserver for system monitoring purposes. In addition, Alpha Warranty is predicated
on this connection to our webserver. The data produced prior to registration can be
synchronized to the webserver.
Step1：Please use the following steps: Open the portal: www.alphaess.com.
Step2：Please fill in "Username", "Password" and click "Login" if you have already
registered.
Advertisement
Table of Contents
Troubleshooting
